http://www.rastavapes.com G Pen Micro is overpriced! Check out our g pen vaporizer from rasta vapes! Our G pen is Micro in size, but not power! <br /> <br />Afterburner G Pen Portable Pen Vaporizer Manual: <br /> <br />1. Fully Charge your Vaporizer Device Before the first use <br /> <br />2. Press the button 3 times in rapid succession to Lock or Unlock. <br /> <br />3. Flashing of time out : 5 Times <br /> <br />4. Flashing of Low battery : 20 times <br /> <br />5. Equipped with a High-capacity battery for 1 to 2 days of continuous use <br /> <br />6. It has a built in safety feature That will temporarily deactivate the atomizer after 10 seconds of continuous atomization. <br /> <br />7. TO USE: After initial charge, pack your G Pen Vape, press button and start vaping in seconds. Enjoy! <br /> <br /> <br /> <br />Charging your Afterburner G Pen Vape: <br /> <br />Once unpackaged, your Afterburner G Pens battery will have a small charge. For the best performance, it's recommended that you charge your battery fully no longer than 30-40min before using. To charge the Afterburner G Pen, plug your wall charger into the outlet, then the other end into the bottom of your battery. A red LED light on the bottom of the battery will light up to show that the battery is charging. <br /> <br />When the battery is completed charging the red LED light will turn off, signifying the battery is completely charged and can be disconnected from the charger. If after 30-40 minutes the light does not turn off, don't worry just unplug and start using. <br /> <br />We recommend avoiding overcharging the G Pen since it may significantly shorten battery life. Overcharging it over night or over an hour is not recommended! <br /> <br />DO NOT LEAVE YOUR BATTERY CONNECTED TO YOUR CHARGER FOR EXTENDED PERIODS OF TIME ONCE CHARGING IS COMPLETE, AS THE BATTERY WILL BEGIN TO DRAIN OVER TIME. <br /> <br />During general use the G Pen battery will inform you when it needs charging when the blue G Pen button's LED illuminates for 5 seconds, then blinks 3 times. <br /> <br /> <br />G Pen Atomizer <br /> <br />Usage: <br />Before use or loading, press and hold your G Pen button for a minimum of ten seconds to break the atomizer in. <br /> <br />Never overload your atomizer - Only a small amount of your product is recommended. Overloading the atomizer can shorten the life of your atomizer. <br /> <br />Never make direct contact with the heating coil. <br /> <br />Maintenance: <br /> <br />Cleaning is necessary to preserve the atomizer. When cleaning the G Pen remove the mouthpiece from the atomizer. Turn the G Pen upside down and hold the AfterBurner G Pen Vape button removing any of your remaining product into a salvageable container or into a heat safe trash dish. Shake out any remaining product into desired receptacle, thus clearing out the atomizer. Remove the atomizer from the battery. Clean the G Pen atomizer using a cotton swab and rubbing alcohol from the inside or exterior of the atomizer. A cotton swab may also be used to clean within the mouthpiece as well.
