MODIFI3D USB 3D Print finishing tool unbox review <br /> <br />Finishing 3D prints should be easy and never a chore. Simply plug in the USB and in less than 15 seconds you are ready to go. You will be able to remove any unwanted material or modify your print without having to redesign and print again! <br /> <br />I just worked out 8 Watts by 5 Volts is 1.6 Amps <br /> <br />USB 2.0 standard allowed 0.5 Amp but I have one port with 2 Amps <br /> <br />I was using a Wall Wart plug in USB, the Amps are most likely low on this, and not enough to power 1.6 Amps needed <br />Four tips <br /> <br />KNIFE TIP <br />Cutting and removing sections including the removal of supports, brims, and rafts from your 3D print. <br /> <br />NEEDLE TIP <br />Great for clearing small holes and features or for detailed layer refinements in hard to reach places. <br /> <br />POINT TIP <br />General purpose tip for larger internal features and holes. Can even be used for making holes after printing! <br /> <br />SCOOP TIP <br />Prefect to remove stringing and imperfections from inside holes or recesses. Can also be used to blend surfaces where blobs have appeared. <br /> <br />MODIFI3D Specs <br />5V 8W <br />Size: 15mm (0.6") x 117mm (4.6") excluding tips <br />Weight: 120g (4.3 oz) <br />Cable: 1.5m (59") long to USB A plug <br />Heats up to 420-450ºC (788-842ºF) in less than 15 seconds <br />Works with PLA, ABS, Nylon and other 3D printing plastics <br /> <br />Protomaker Black Sprint Original 3D Printer <br />https://protomaker3dprinter.wordpress.com/ <br />Tweets about 3D Printers: tips, hardware software, filament ,etc... <br />https://twitter.com/myvideostowatch <br />.
