Surprise Me!

Audi A4 B7 Mini H1 Bi-xenon projector headlight retrofit tutorial

2018-07-11 171 Dailymotion

http://www.retrofitlab.com/projector-... <br />Check out our new Facebook group: https://www.facebook.com/groups/Europ... <br /> <br />The Audi A4 B7 is a very classic car with a luxurious appearance. Your car didn't came out of the Audi factory with OEM xenon headlights? No need to worry. With our Bi-xenon mini H1 twin kit it's now possible to transform your headlights to true Bi-xenon projectors! Check out our full instruction video on how to retrofit your headlight with these awesome projectors and compete with OEM setups for a fraction of their cost! <br /> <br />0:01 Remove the caps from the rear <br />0:05 Bake the headlight to soften the sealing <br />0:11 We put the headlight in a carton box and heat it <br />0:15 1600 Watt heatgun for 16 minutes <br />0:23 Remove the lens clips and rubber <br />0:44 Seperate the lens from the housing using a flat screw driver <br />1:14 Remove the H7 halogen bulb cap <br />1:20 break off the cap channel with a plier <br />1:28 Place the small rubber washer over the projector shaft <br />1:33 Insert the Bi-xenon solenoid wires through the cap shaft and insert the projector through the fitting <br />1:43 Place the H7 adapter ring and secure the projector nut <br />1:59 Don't tighten it fully yet, you might want to do some final rotational adjustment when the headlights are mounted on the car <br />2:04 Mount the bulb holder <br />2:20 Click the shroud centric ring inside the shroud (this shroud has been modified for fitment) <br />2:23 Apply a few drops of glue to be sure the shroud will stay on <br />2:50 Remove all finger prints using a fine cloth <br />3:00 If you want, apply some butyl to make sure the headlight will be free of moisture <br />3:20 Press the lens on the housing and bake it again <br />3:48 Now that the sealant is soft, press the lens on the housing using pliers and secure the lens by placing the metal clips <br />4:17 Place the solenoid plug back on the wires <br />4:25 Connect the H7 high beam splitter for the solenoid to function together with the H7 halogen high beam <br />4:49 Drill a 20-22mm hole in the bulb cap to guide the wires through <br />5:16 The wires will be connected to the ballast and H7 low beam plug. Because the Audi A4 B7 has Canbus, this is the only wiring setup that can be used <br />5:22 Insert the bulb in the projector and secure it with the clip <br />5:48 Connect the 12V ballast wires correctly, red to the yellow cable (+ positive) and black to brown (- negative) <br />6:07 Click the cap back on, you are ready to do mount the headlight to the car and enjoy a luxurious Bi-xenon projector headlight! :-) <br /> <br /> <br />info@retrofitlab.com <br />+31 (0)341-820220 <br /> <br />Retrofitlab.com <br />Tolweg 2W <br />3851SK Ermelo <br />Netherlands <br /> <br />http://www.retrofitlab.com/projector-...

Buy Now on CodeCanyon