I wanted to show you guys how to crimp a dtm connector and create a can bus wiring harness its simply 4 wires. Can Hi , can Lo , 12Volt + and ground !<br /><br />The Can Hi and low needs to be twisted 1 rotation per inch of wire. <br /><br />I used 18 AWG wire and went with a green for can low ( think ground is green like grass ) and white for can hi. I have also seen people use yellow as Hi.<br /><br />I used Dtm4 connectors here but if you are doing the Motec keypads it calls for a DT4.<br /><br />You can buy all this stuff over at @prowireusa<br /><br />For a list of wiring supplies I use check out https://bit.ly/3z5QsrT<br /><br />Watch the full video https://youtu.be/jH9MaQNlxks<br /><br />#motorsportswiring #deutschconnector
