they have a lot of info like:<br />Cut a small flat steel plate measuring 60x30x6mm. Fix & weld it toward the crankshaft end as shown in diagram6.<br /><br />Cut out three pieces of plywood measuring 13mm each as illustrated in diagram7.<br /><br />The coil former measures 50mmx50mx13 thick. It consists of rounded corners. The 2 cheek pieces measures 125mmx125mm & there are 20mm wide notches top & bottom in each. The notches help in securing masking tape under the coil to tape up prior to removing it from the notches.<br /><br />Stack the cheek pieces with the notches in line.<br /><br />Drill holes for mounting bolts. These holes should be 16mm in diameter & at least 40mm apart. You need to make use of a drill press in order to drill the holes square to the plywood.<br /><br />Focus on passing 2 bolts through the holes in the flat plate. Also past bolt on cheek pies with coil former in between. Try using butterfly nuts.
